Material – EN AW – 6063 T66

Holding tracks for installation of large- and small-size cladding panels with visible clip-on fixing, e.g. ceramics 40/40, 60/60.

It consists of vertical holding tracks and brackets. The holding tracks bear the cladding panels by way of holding clips. The holding tracks are located so that they are behind each vertical panel joint. They are connected to the brackets with rivets or screws.

The brackets form sliding and fixed points. At the sliding points, force-free installation in vertical slot holes is possible. The sliding points only bear horizontal loads (wind). The fixed points bear horizontal and vertical loads (dead weight). Each holding track has one fixed point.

Optionally, the brackets have an installation help making fixing and holding of the holding track possible. For minimizing thermal bridges, thermostop-elements are offered for thermal separation.

Statical proof is given by SYSTEA® for each project individually.

Holding Tracks

  • T-profiles T 65/50, T 80/50 and T 100/50

Consoles / Brackets

According to your selection, the following parameters are possible:

  • thermal efficiency: A+ to A
  • fire protection classification: non-flammable
  • up to 400mm reach (possible extension up to 200mm)

> To select the consoles / brackets


  • Outer corner profiles, angular
  • Ventilation angles for lower facade border
  • Water stem profiles

UKLA (05)

Holding Tracks for ceramic wall panels (clip-on fixing)